对于运行OSPF协议的路由器来说,RouterID是路由器的唯一标识,所以协议规定：必须保证RouterID在如下范围之内唯一（）。You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which
Which of the following are types of flow control? (Choose three)路由器的配置文件startup-config存放在()里Buffering#
Cut-through
Windowing#
Congestion avoidance#
Load balancingRAM
ROM
FLASH
NVRAM#解析：
A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?在OSPF的DR/BDR选举过程中,在路由器有相同的接
Assuming you build networks to exact specifications, what is the recommended maximum length a 10BaseT cable can be before it has to be segmented or repeated?You have a class C network, and you need to
如果网络中的路由器都是cisco路由器,则优先选择哪一个路由协议（）There are 2 switches in the Ezonexam LAN, with no routers. Ports 1, 2 & 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 & 6 are
网络中经常使用“帧中继”服务,请选出帧中继的优点（）交换机工作在OSI七层模型的哪一层()You have just purchased a brand new router and wish to have the router prompt you through the initial configuration co
EIGRP的管理距离（）The Ezonexam network administrator has just issued the "switchport trunk native vlan 998" command on switch VE2. What is the function of this command?90
100
110#
120It designates VL
“ipaccess-group”命令在接口上缺省的应用方向是什么"（）。What kind of cable should be used to establish a trunked line between two Catalyst switches?in
具体取决于接口应用哪个访问控制列表
out#
无缺省值A
交换机转发数据到目的地依靠()You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)访问控制列表分为标准和扩展两种。下
What are two results of entering the VESwitch(config)# vtp mode client command on a Catalyst switch in the Ezonexam LAN? (Choose two.)下列路由协议中,属于链路状态路由协议的是（）What are two characteri
A Ezonexam switch is configured with all ports assigned to VLAN 2. In addition, all ports are configured as full-duplex FastEthernet. What is the effect of adding switch ports to a new VLAN on this sw
