计算机2022思科认证模拟考试题188

1. [单选题]What kind of cable should be used to establish a trunked line between two Catalyst switches?

A. A straight-through cable
B. An EIA/TIA-232 serial cable
C. An auxiliary cable
D. A modem cable
E. A cross-over cable

2. [单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)

A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.

3. [单选题]You are given a PC, a router, and a cable. Select the correct combination that will allow you to log into router VE1 locally using a terminal emulation program such as HyperTerminal.

A. Connect the PC's COM port to the router's console port using a straight-through cable.
B. Connect the PC's COM port to the router's console port using a rollover cable.
C. Connect the PC's COM port to the router's Ethernet port using a straight-through cable.
D. Connect the PC's Ethernet port to the router's Ethernet port using a rollover cable.
E. Connect the PC's Ethernet port to the router's Ethernet port using a straight- through cable.
F. F. None of the above

4. [单选题]混合型协议既具有“距离矢量路由协议”的特性，又具有“链路状态路由协议”的特性，下列协议中属于混合型协议的是：()

A. RIP
B. OSPF
C. EIGRP
D. IGRP

5. [单选题]IP地址为：192.168.50.70，掩码为：255.255.255.248，则该IP和掩码结合划分子网时，每个子网的容量为（）

A. 8
B. 4
C. 12
D. 6

6. [单选题]You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which statement is true about full-duplex Ethernet when comparing to half-duplex Ethernet?

A. Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C. Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E. None of the above

7. [单选题]At which layer of the OSI model does the protocol that provides the information displayed by the "show cdp neighbors" command operate?

A. Transport
B. Physical
C. Application
D. Data link
E. Network

8. [单选题]The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?

A. Assign the switch a higher MAC address than the other switches in the network have
B. Establish a direct link from the switch to all other switches in the network
C. Configure the switch full-duplex operation and configure the other switches for half-duplex operation
D. Configure the switch so that it has lower priority than other switches in the network
E. None of the above

9. [多选题]Which three statements are true about the operation of a full-duplex Ethernet network, which is being used in the Ezonexam LAN? (Choose three)

A. Ethernet hub ports are preconfigured for full-duplex mode.
B. The host network card and the switch port must be capable of operating in full-duplex mode.
C. There are no collisions in full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
E. A dedicated switch port is required for each full-duplex node.

10. [单选题]A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?

A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.
E. None of the above

查看答案&解析 点击获取本科目所有试题

本文链接：https://www.zhukaozhuanjia.com/download/xw7y0e.html