1. [单选题]两台路由器直连到一起，应该使用的线缆为（）
A. 交叉线缆
B. 直通线缆
C. 反转线缆
D. 任意线缆
2. [单选题]How can a Ezonexam administrator determine if a router has been configured when it is first powered up?
A. A configured router prompts for a password
B. A configured router goes to the privileged mode prompt
C. An un configured router goes into the setup dialog
D. An un configured router goes to the enable mode prompt
3. [单选题]Ezonexam has implemented the use of the Virtual Trunking Protocol (VTP). Which statement below accurately describes a benefit of doing this?
A. VTP will allow physically redundant links while preventing switching loops
B. VTP will allow switches to share VLAN configuration information
C. VTP will allow a single port to carry information to more than one VLAN
D. VTP will allow for routing between VLANs
E. None of the above
4. [单选题]路由器上端口fa0/0,其最大传输速率是（）Mbit/s
A. 128
B. 10
C. 100
D. 1000
5. [单选题]如果网络中的路由器都是cisco路由器，则优先选择(priority selection)哪一个路由协议（）
A. RIP
B. EIGRP
C. IGRP
D. OSPF
6. [单选题]下列哪个network命令会告知此路由器开始使用IP地址为10.1.1.1、10.1.100.1和10.1.120.1的接口上的OSPF（）
A. network 10.0.0.0 255.0.0.0 area 0
B. network 10.0.0.0 0.255.255.255 area 0
C. network 10.0.0.1 0.0.0.255 area 0
D. network 10.0.0.1 0.0.255.255 area 0
7. [单选题]关于帧中继的说法，正确的是（）
A. 速率最大为1Mbit/s
B. 不提供差错校验功能
C. 可以偷占带宽
D. 数据传输质量高于DDN
8. [单选题]对于运行OSPF协议的路由器来说，RouterID是路由器的唯一标识，所以协议规定：必须保证RouterID在如下范围之内唯一（）。
A. 网段内
B. 区域内
C. 自治系统内
D. 整个因特网
9. [单选题]You are a senior network administrator at Ezonexam, and while performing the password recovery procedure on your 2500 series Cisco router, you type in the following command:o/r 0x2142
A. What is the purpose of this command?
B. It is used to restart the router.
C. It is used to bypass the configuration in NVRAM.
D. It is used to enter ROM Monitor mode.
E. It is used to view the lost password.
F. It is used to save the changes to the configuration.
10. [多选题]With regard to Ethernet media access methods, which of the following are true?(Choose all that apply.)
A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.
