【名词&注释】
物理层(physical layer)、数据链路层(data link layer)、无限制
[单选题]What kind of cable should be used to establish a trunked line between two Catalyst switches?
A. A straight-through cable
B. An EIA/TIA-232 serial cable
C. An auxiliary cable
D. A modem cable
E. A cross-over cable
查看答案&解析
点击获取本科目所有试题
举一反三：
[多选题]You have just installed a new web server on the Ezonexam network. You are required to ensure that the web server is accessible from the Internet. The network uses private addressing, so an IP-to-registered address mapping is required.To do this, you enter the following command:
A. Ezonexam(config) ip nat inside source static 192.168.2.1
B. 198.18.1.254
C. You unsuccessfully try to ping the Internet from a PC host on the LAN. During the troubleshooting process, you enter the "show ip nat translations" command but the output is blank.
D. What is the most likely cause of the problem?
E. The keyword overload is missing from the command.
F. The NAT pool must be defined first.
G. An access list must be defined to create static NAT translations.
H. The interfaces must be configured for NAT.
I. None of the above
[单选题]The IP network 210.106.14.0 is subnetted using a /24 mask. How many usable networks and host addresses can be obtained from this?
A. 1 network with 254 hosts
B. 4 networks with 128 hosts
C. 2 networks with 24 hosts
D. 6 networks with 64 hosts
E. 8 networks with 36 hosts
[单选题]RIP协议负载均衡的路径数量为（）
A. 无限制
B. 最多4条
C. 最多5条
D. 最多6条
[单选题]介质工作在OSI的哪一层（）
A. 物理层
B. 数据链路层
C. 网络层
D. 传输层
[多选题]You need to configure a default route on a Ezonexam router. Which command will configure a default route on a router?
A. VE1(config) ip route 0.0.0.0 10.1.1.0 10.1.1.1
B. VE1(config) ip default-route 10.1.1.0
C. VE1(config) ip default-gateway 10.1.1.0
D. VE1(config) ip route 0.0.0.0 0.0.0.0 10.1.1.1
[单选题]命令ip nat pool aaa 192.1.1.2 192.1.1.10 netmask 255.255.255.0的作用是()
A. 指定可访问地址
B. 定义地址池
C. 指定路由
D. 定义哪些地址可以进行地址转换
[单选题]After working all night and successfully configuring a Cisco router for the Ezonexam network you save your changes on the startup config, reboot the router, and go out for a cigarette. When you return, none of your changes are active and the router boots to the initial configuration mode! Which of the choices below indicates the source of your problem?
A. Hardware failure in NVRAM prevents the router from loading the config
B. Startup-config in flash is corrupt and cannot be analyzed
C. Router configuration-register set to bypass startup configuration
D. Startup-config in NVRAM is corrupt and cannot be analyzed
E. None of the above
本文链接：https://www.zhukaozhuanjia.com/download/w7k0e0.html
