不凡考网

计算机2020思科认证网络工程师考前点睛模拟考试127

来源: 不凡考网    发布:2020-05-07     [手机版]    
  • 下载次数:
  • 支持语言:
  • 626次
  • 中文简体
  • 文件类型:
  • 支持平台:
  • pdf文档
  • PC/手机

导读

不凡考网发布计算机2020思科认证网络工程师考前点睛模拟考试127相关信息,更多计算机2020思科认证网络工程师考前点睛模拟考试127的相关资讯请访问不凡考网计算机类考试频道。

1. [单选题]交换机转发数据到目的地(destination)依靠()

A. 路由表
B. MAC地址表
C. 访问权限表
D. 静态列表


2. [单选题]How can a Ezonexam administrator determine if a router has been configured when it is first powered up?

A. A configured router prompts for a password
B. A configured router goes to the privileged mode prompt
C. An un configured router goes into the setup dialog
D. An un configured router goes to the enable mode prompt


3. [单选题]You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which statement is true about full-duplex Ethernet when comparing to half-duplex Ethernet?

A. Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C. Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E. None of the above


4. [多选题]With regard to Ethernet media access methods, which of the following are true?(Choose all that apply.)

A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.


5. [单选题]OSI七层模型中,数据链路层(data link layer)的数据封装名称为()

A. 比特
B. 帧
C. 包
D. 段


6. [单选题]在地址转换中,()用来规定哪些数据包需要进行地址转换

A. 在线用户表
B. 访问控制列表
C. MAC地址表
D. 路由表


7. [多选题]下列哪一设备工作时,要用到OSI的七个层(一层到七层)()

A. PC
B. 网管机
C. WEB服务器
D. 交换机
E. 路由器


8. [单选题]路由器上,命令“show int s0”的显示结果为:Serial0 is up,line protocol is down出现该结果的可能原因是()

A. 端口处于关闭状态
B. 物理端口被烧毁
C. 两端设备协议不一致
D. 路由表中无路由


9. [单选题]备份路由器IOS的命令是:()

A. copy flash tftp
B. copy running-configt ftp
C. copy IOS tftp
D. copy startup-configt ftp


10. [单选题]基本IP访问权限表的表号范围是:()

A. 1—100
B. 1-99
C. 100-199
D. 800-899


  • 查看答案&解析 点击获取本科目所有试题

  • 本文链接:https://www.zhukaozhuanjia.com/download/vexp8l.html
    推荐阅读
    @2019-2026 不凡考网 www.zhukaozhuanjia.com 蜀ICP备20012290号-2