1. [单选题]EIGRP的管理距离（）
A. 90
B. 100
C. 110
D. 120
2. [单选题]TELNET工作在OSI哪一层（）
A. 会话层(session layer)
B. 表示层
C. 传输层
D. 应用层
3. [单选题]当拓扑信息完成交换，相邻路由器具有相同的LSDB时，下列哪项OSPF邻居状态是希望得到的()
A. 2-WAY
B. FULL
C. Exchange
D. Loading
4. [单选题]扩展ACL和标准ACL的区别（）。
A. 标准的ACL在禁止和允许方面比扩展的ACL更高的精度
B. 扩展的ACL核查数据包的源地址(source address)和目标地址和端口号(port number)
C. 他们都可以查端口号(port number)
D. 他们都可以查特殊协议和其他参数
5. [单选题]两个VLAN之间要想通信，应该使用的设备是（）
A. 集线器
B. 二层交换机
C. 路由器
D. PC机
6. [单选题]The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?
A. Assign the switch a higher MAC address than the other switches in the network have
B. Establish a direct link from the switch to all other switches in the network
C. Configure the switch full-duplex operation and configure the other switches for half-duplex operation
D. Configure the switch so that it has lower priority than other switches in the network
E. None of the above
7. [多选题]What are two characteristics of "store and forward" switching? (Select two answer choices)
A. Latency fluctuates regardless of frame. size.
B. The switch receives the complete frame. before beginning to forward it.
C. Latency through the switch varies with frame. length.
D. The switch checks the destination address upon receipt of headers.
8. [单选题]某台PC，能ping通路由器，但不能telnet到路由器，可能的原因是（）
A. PC的IP地址设置错误
B. 路由器端口IP设置错误
C. 路由器端口处于关闭状态
D. telnet密码未设置
9. [单选题]You are a senior network administrator at Ezonexam, and while performing the password recovery procedure on your 2500 series Cisco router, you type in the following command:o/r 0x2142
A. What is the purpose of this command?
B. It is used to restart the router.
C. It is used to bypass the configuration in NVRAM.
D. It is used to enter ROM Monitor mode.
E. It is used to view the lost password.
F. It is used to save the changes to the configuration.
10. [多选题]You have just installed a new web server on the Ezonexam network. You are required to ensure that the web server is accessible from the Internet. The network uses private addressing, so an IP-to-registered address mapping is required.To do this, you enter the following command:
A. Ezonexam(config) ip nat inside source static 192.168.2.1
B. 198.18.1.254
C. You unsuccessfully try to ping the Internet from a PC host on the LAN. During the troubleshooting process, you enter the "show ip nat translations" command but the output is blank.
D. What is the most likely cause of the problem?
E. The keyword overload is missing from the command.
F. The NAT pool must be defined first.
G. An access list must be defined to create static NAT translations.
H. The interfaces must be configured for NAT.
I. None of the above
