1. [单选题]在路由表中到达同一网络的路由有：静态路由、RIP路由、IGRP路由，OSPF路由，则路由器会选用哪条路由传输数据：()
A. 静态路由
B. RIP路由
C. IGRP路由
D. OSPF路由
2. [单选题]The Ezonexam corporate LAN consists of one large flat network. You decide to segment this LAN into two separate networks with a router. What will be the affect of this change?
A. The number of broadcast domains will be decreased.
B. It will make the broadcasting of traffic between domains more efficient between segments.
C. It will increase the number of collisions.
D. It will prevent segment 1's broadcasts from getting to segment 2.
E. It will connect segment 1's broadcasts to segment 2.
3. [单选题]以下（）LSA类型是ASBR来宣告外部路由信息的。（）
A. 类型1
B. 类型2
C. 类型3
D. 类型4
E. 类型5
4. [多选题]The Ezonexam network administrator needs to determine what LAN devices to install on the Ezonexam network. What are two advantages of using Layer 2 Ethernet switches over hubs? (Choose two)
A. Allowing simultaneous frame. transmissions
B. Increasing the size of broadcast domains
C. Increasing the maximum length of UTP cabling between devices
D. Filtering frames based on MAC addresses
E. Decreasing the number of collision domains
5. [单选题]配置路由器特权用户“加密密码”的命令是：()
A. password
B. enable password
C. enable secret
D. passwd
6. [单选题]IP地址为：192.168.50.70，掩码为：255.255.255.248，则该IP和掩码结合，共划分了多少个子网（不包括全0子网和全1子网）（）
A. 8
B. 30
C. 6
D. 14
7. [单选题]扩展ACL和标准ACL的区别（）。
A. 标准的ACL在禁止和允许方面比扩展的ACL更高的精度
B. 扩展的ACL核查数据包的源地址(source address)和目标地址和端口号
C. 他们都可以查端口号
D. 他们都可以查特殊协议和其他参数
8. [单选题]查看路由表的命令是：()
A. show interface
B. show run
C. show ip route
D. show table
9. [单选题]You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which statement is true about full-duplex Ethernet when comparing to half-duplex Ethernet?
A. Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C. Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E. None of the above
10. [单选题]At which layer of the OSI model does the protocol that provides the information displayed by the "show cdp neighbors" command operate?
A. Transport
B. Physical
C. Application
D. Data link
E. Network
