1. [单选题]路由器上的命令“show version”的功能是（）
A. 显示版本信息
B. 显示端口配置信息
C. 显示路由表
D. 显示路由协议信息
2. [单选题]PPP工作在OSI的哪一层（）
A. 物理层(physical layer)
B. 数据链路层(data link layer)
C. 网络层
D. 传输层
3. [单选题]介质100BaseT的最大传输距离是：()
A. 10m
B. 100m
C. 1000m
D. 500m
4. [单选题]路由器上，命令“show int s0”的显示结果为：Serial0 is up,line protocol is down出现该结果的可能原因是（）
A. 端口处于关闭状态
B. 物理端口被烧毁
C. 两端设备协议不一致
D. 路由表中无路由
5. [单选题]配置路由器时，封装PPP协议的命令是：()
A. encap ppp
B. ppp
C. group ppp
D. int ppp
6. [单选题]A Ezonexam technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command.In which OSI layer is the problem most likely occurring?
A. Physical
B. Data link
C. Network layer
D. Transport layer
E. Application layer
7. [单选题]标准访问控制列表的数字标识范围是（）。
A. 1-50
B. 1-99
C. 1-100
D. 1-199
8. [单选题]工作在OSI第三层(layer 3)的设备是：()
A. 网卡
B. 路由器
C. 交换机
D. 集线器
9. [单选题]You are given a PC, a router, and a cable. Select the correct combination that will allow you to log into router VE1 locally using a terminal emulation program such as HyperTerminal.
A. Connect the PC's COM port to the router's console port using a straight-through cable.
B. Connect the PC's COM port to the router's console port using a rollover cable.
C. Connect the PC's COM port to the router's Ethernet port using a straight-through cable.
D. Connect the PC's Ethernet port to the router's Ethernet port using a rollover cable.
E. Connect the PC's Ethernet port to the router's Ethernet port using a straight- through cable.
F. F. None of the above
10. [单选题]RIP路由协议认为“网络不可到达”的跳数是：()
A. 8
B. 16
C. 24
D. 100
