1. [单选题]FTP工作在OSI哪一层（）
A. 会话层(session layer)
B. 表示层
C. 传输层
D. 应用层
2. [单选题]What kind of cable should be used to establish a trunked line between two Catalyst switches?
A. A straight-through cable
B. An EIA/TIA-232 serial cable
C. An auxiliary cable
D. A modem cable
E. A cross-over cable
3. [单选题]下列对访问控制列表的描述不正确的是（）。
A. 访问控制列表能决定数据是否可以到达某处
B. 访问控制列表可以用来定义某些过滤器
C. 一旦定义了访问控制列表，则其所规范的某些数据包就会严格被允许或拒绝
D. 访问控制列表可以应用于路由更新的过程当中
4. [多选题]The Ezonexam network administrator needs to determine what LAN devices to install on the Ezonexam network. What are two advantages of using Layer 2 Ethernet switches over hubs? (Choose two)
A. Allowing simultaneous frame. transmissions
B. Increasing the size of broadcast domains
C. Increasing the maximum length of UTP cabling between devices
D. Filtering frames based on MAC addresses
E. Decreasing the number of collision domains
5. [单选题]下面哪个操作可以使访问控制列表真正生效（）。
A. 将访问控制列表应用到接口上
B. 定义扩展访问控制列表
C. 定义多条访问控制列表的组合
D. 用access-list命令配置访问控制列表
6. [多选题]Two stations on the Ezonexam LAN transmit at the same time, resulting in a collision. What happens when a collision occurs on the network? (Choose all that apply)
A. Each device on the Ethernet segment stops transmitting for a short time.
B. A jam signal informs all devices that a collision occurred.
C. When data transmission resumes, the devices that were involved in the collision have priority to transmit.
D. The devices that are involved in the collision stops transmitting for a short time.
E. The collision invokes a random back-off algorithm.
7. [多选题]As the Ezonexam network administrator, you are required to have a firm understanding of the OSI model. Why does the data communication industry use the layered OSI reference model? (Choose two)
A. It enables equipment from different vendors to use the same electronic components, thus saving research and development funds
B. It encourages industry standardization by defining what functions occur at each layer of the model
C. It divides the network communication process into smaller and simpler components; thus aiding component development, design and troubleshooting
D. It provides a means by which changes in functionality in one layer require changes in other layers
E. It supports the evolution of multiple competing standards and thus provides business opportunities for equipment manufacturers
8. [单选题]IP地址为：192.168.50.70，掩码为：255.255.255.248，则该IP地址所在子网的子网有效IP为（）
A. 192.168.50.33---192.168.50.39
B. 192.168.50.41---192.168.50.50
C. 192.168.50.65---192.168.50.70
D. 192.168.50.66---192.168.50.75
9. [单选题]Which command on router EzonexamA will assign the last usable IP address from the 192.168.32.128/28 subnetwork to a router interface?
A. EzonexamA(config-if) ip address 192.168.32.142 255.255.255.240
B. EzonexamA(config-if) ip address 192.168.32.143 255.255.255.240
C. EzonexamA(config-if) ip address 192.168.32.158 255.255.255.240
D. EzonexamA(config-if) ip address 192.168.32.145 255.255.255.240
E. EzonexamA(config-if) ip address 192.168.32.144 255.255.255.240
F. F. EzonexamA(config-if) ip address 192.168.32.158 255.255.255.240
G. G. None of the above
10. [多选题]CDP is being used throughout the Ezonexam network. What are two reasons why the Ezonexam network administrator would use CDP? (Choose two)
A. To determine the status of network services on a remote device
B. To obtain the IP Address of a connected device in order to telnet to the device
C. To verify the type of cable interconnecting two devices
D. To verify Layer 2 connectivity between two devices when Layer 3 fails
E. To obtain VLAN information from directly connected swticehs
F. F. To determine the status of the routing protocols between directly connected routers
G. G. To support automatic network failover during outages
