1. [单选题]标准访问控制列表应被放置的最佳位置是在（）。
A. 越靠近数据包的源越好
B. 越靠近数据包的目的地越好
C. 无论放在什么位置都行
D. 入接口方向的任何位置
2. [单选题]地址转换NAT的优点是()
A. 地址转换对于报文内容中含有有用的地址信息的情况很难处理
B. 地址转换可以缓解地地址短缺的问题
C. 地址转换不能处理IP报头加密的情况
D. 地址转换由于隐藏了内部主机地址，有时会使网络调试变得复杂
3. [单选题]关于静态NAT，下面（）说法是正确的。
A. 静态NAT转换在缺省情况下24小时后超时
B. 静态NAT转换从地址池中分配
C. 静态NAT将内部地址一对一(one to one)静态映射到内部全局地址
D. CISCO路由器缺省使用了静态NAT
4. [单选题]Which type of cable should be used to make a connection between the Fa0/0 port on a router and the Fa0/0 port switch?
A. Rollover cable
B. Console cable
C. Crossover cable
D. Straight-through cable
E. Serial cable
5. [单选题]能够分配给设备的IP，应该是（）
A. 网络有效IP
B. 网络号
C. 网络广播地址
D. 任意IP
6. [单选题]路由器上，设置端口速率的命令是（）
A. clock rate
B. bandwidth
C. set
D. encap
7. [单选题]At which layer of the OSI model does the protocol that provides the information displayed by the "show cdp neighbors" command operate?
A. Transport
B. Physical
C. Application
D. Data link
E. Network
8. [多选题]CDP is being used throughout the Ezonexam network. What are two reasons why the Ezonexam network administrator would use CDP? (Choose two)
A. To determine the status of network services on a remote device
B. To obtain the IP Address of a connected device in order to telnet to the device
C. To verify the type of cable interconnecting two devices
D. To verify Layer 2 connectivity between two devices when Layer 3 fails
E. To obtain VLAN information from directly connected swticehs
F. F. To determine the status of the routing protocols between directly connected routers
G. G. To support automatic network failover during outages
9. [多选题]默认情况下，IGRP衡量路径好坏时，考虑的因素为（）
A. 带宽
B. 可靠性
C. 最大传输单元
D. 延时
10. [多选题]Which of the following are types of flow control? (Choose three)
A. Buffering
B. Cut-through
C. Windowing
D. Congestion avoidance
E. Load balancing
