1. [单选题]You have just purchased a brand new router and wish to have the router prompt you through the initial configuration commands. Which router mode does this describe?
A. ROM Monitor mode
B. SETUP mode
C. Autoflash mode
D. RXBOOT mode
E. None of the above
2. [单选题]A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?
A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.
E. None of the above
3. [单选题]OSI七层模型中，数据链路层(data link layer)的数据封装名称为（）
A. 比特
B. 帧
C. 包
D. 段
4. [单选题]During the boot sequence, a Ezonexam 2800 series router needs to locate and load an operating system. What is the default order the router uses to find an operating system?
A. ROM, TFTP server, Flash
B. Flash, TFTP server, ROM
C. Flash, NVRAM, TFTP server
D. Flash, ROM, TFTP server
E. Flash, TFTP server, RAM
5. [单选题]Assuming you build networks to exact specifications, what is the recommended maximum length a 10BaseT cable can be before it has to be segmented or repeated?
A. 100 meters
B. 100 feet
C. 100 yards
D. 200 meters
E. None of the above
6. [单选题]如果网络中的路由器都是cisco路由器，则优先选择哪一个路由协议（）
A. RIP
B. EIGRP
C. IGRP
D. OSPF
7. [单选题]路由器上，清空路由表的命令是（）
A. clear ip
B. delete ip route
C. delete route
D. clearip route*
8. [单选题]You wish to segment your LAN into multiple broadcast domains. Which technology method should you implement in order to do this?
A. Transparent bridging
B. Cut-through switching
C. Fragment-free switches
D. Virtual LANs
E. Store-and-forward switching
F. F. None of the above
9. [多选题]The LAN needs are expanding at the Ezonexam corporate office, which is quickly growing. You are instructed to enlarge the area covered by a single LAN segment on the Ezonexam network.Which of the following are layer 1 devices that you can use? (Choose all that apply.)
A. A switch
B. A router
C. A network adapter card
D. A hub
E. A repeater
10. [单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
