1. [多选题]You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)
A. Switch(vlan) mode trunk
B. Switch(config) switchport access mode trunk
C. Switch(config-if) switchport mode trunk
D. Switch(config-if) switchport trunk encapsulation dot1q
E. Switch(config) switchport access mode 1
F. F. Switch(vlan) trunk encapsulation dot1q
2. [单选题]哪个ACL可允许主机10.220.158.10访问web服务器192.168.3.244()
A. access-list 101 permit tcp host 10.220.158.10 eq 80 host 192.168.3.224
B. access-list 101 permit tcp 10.220.158.10 0.0.0.0 host 192.168.3.224 0.0.0.0 eq 80
C. access-list 101 permit host 10.220.158.10 0.0.0.0 host 192.168.3.224 0.0.0.0 eq 80
D. access-list 101 permit tcp 10.220.158.10 0.0.0.0 host 192.168.3.224 eq 80
3. [单选题]把指定端口添加到VLAN的命令是：()
A. vlan
B. vlan-member ship
C. vtp
D. switch port
4. [多选题]Regarding DHCP (dynamic host configuration protocol), which two of the following choices below are true? (Select two answer choices)
A. The DHCP Discover message uses FF-FF-FF-FF-FF as the Layer 2 destination address.
B. The DHCP Discover message uses UDP as the transport layer protocol.
C. The DHCP Discover message uses a special Layer 2 multicast address as the destination address.
D. The DHCP Discover message uses TCP as the transport layer protocol.
E. The DHCP Discover message does not use a Layer 2 destination address.
F. F. The DHCP Discover message does not require a transport layer protocol.
5. [单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
