1. [多选题]In which Spanning-Tree states does a switch port learn MAC addresses? (Select two)
A. Blocking
B. Listening
C. Forwarding
D. Learning
E. Relaying
2. [单选题]标准访问控制列表的数字标识范围是（）。
A. 1-50
B. 1-99
C. 1-100
D. 1-199
3. [单选题]帧中继环境中，在物理端口上，建立子接口的命令是（）
A. create
B. interface
C. encapsulation
D. ip address
4. [单选题]How can a Ezonexam administrator determine if a router has been configured when it is first powered up?
A. A configured router prompts for a password
B. A configured router goes to the privileged mode prompt
C. An un configured router goes into the setup dialog
D. An un configured router goes to the enable mode prompt
5. [单选题]The IP network 210.106.14.0 is subnetted using a /24 mask. How many usable networks and host addresses can be obtained from this?
A. 1 network with 254 hosts
B. 4 networks with 128 hosts
C. 2 networks with 24 hosts
D. 6 networks with 64 hosts
E. 8 networks with 36 hosts
6. [多选题]Regarding DHCP (dynamic host configuration protocol), which two of the following choices below are true? (Select two answer choices)
A. The DHCP Discover message uses FF-FF-FF-FF-FF as the Layer 2 destination address.
B. The DHCP Discover message uses UDP as the transport layer protocol.
C. The DHCP Discover message uses a special Layer 2 multicast address as the destination address.
D. The DHCP Discover message uses TCP as the transport layer protocol.
E. The DHCP Discover message does not use a Layer 2 destination address.
F. F. The DHCP Discover message does not require a transport layer protocol.
7. [单选题]TCP23是（）协议端口号(port number)；UDP69是（）端口号(port number)；TCP80是（）端口号(port number)。
A. TELNET FTP HTTP
B. FTPT FTP HTTP
C. TELNET TFTP HTTP
D. TELNET DNS HTTP
8. [单选题]标准访问控制列表应被放置的最佳位置是在（）。
A. 越靠近数据包的源越好
B. 越靠近数据包的目的地越好
C. 无论放在什么位置都行
D. 入接口方向的任何位置
9. [单选题]A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?
A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.
E. None of the above
10. [单选题]During the boot sequence, a Ezonexam 2800 series router needs to locate and load an operating system. What is the default order the router uses to find an operating system?
A. ROM, TFTP server, Flash
B. Flash, TFTP server, ROM
C. Flash, NVRAM, TFTP server
D. Flash, ROM, TFTP server
E. Flash, TFTP server, RAM
