1. [单选题]You are given a PC, a router, and a cable. Select the correct combination that will allow you to log into router VE1 locally using a terminal emulation program such as HyperTerminal.
A. Connect the PC's COM port to the router's console port using a straight-through cable.
B. Connect the PC's COM port to the router's console port using a rollover cable.
C. Connect the PC's COM port to the router's Ethernet port using a straight-through cable.
D. Connect the PC's Ethernet port to the router's Ethernet port using a rollover cable.
E. Connect the PC's Ethernet port to the router's Ethernet port using a straight- through cable.
F. F. None of the above
2. [单选题]对于使用链路状态路由协议的路由器如何选择最佳路线到达子网，下列哪项是正确的（）
A. 路由器会发现链路状态数据库中的最佳路由
B. 通过针对链路状态数据库中的信息运行SPF算法，路由器会计算出最佳路由
C. 路由器将比较每个邻居接收到的更新中为子网列出的标准，并挑选最佳标准路由
D. 路由器会使用具有最低条数的路径
3. [单选题]在路由表中到达同一网络的路由有：静态路由、RIP路由、IGRP路由，OSPF路由，则路由器会选用哪条路由传输数据：()
A. 静态路由
B. RIP路由
C. IGRP路由
D. OSPF路由
4. [单选题]路由器上，命令“show int s0”的显示结果为：Serial0 is up,line protocol is down出现该结果的可能原因是（）
A. 端口处于关闭状态
B. 物理端口被烧毁
C. 两端设备协议不一致
D. 路由表中无路由
5. [单选题]The Ezonexam LAN is upgrading all devices to operate in full duplex. Which statement is true about full-duplex Ethernet in comparison to half-duplex Ethernet?
A. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
B. Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link
C. Full-duplex Ethernet can provide higher throughout than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex ethernet uses a jam signal
E. None of the above
6. [单选题]访问控制列表分为标准和扩展两种。下面关于ACL的描述中，错误的是()。
A. 标准ACL可以根据分组中的IP源地址(source address)进行过滤
B. 扩展ACL可以根据分组中的IP目标地址进行过滤
C. 标准ACL可以根据分组中的IP目标地址进行过滤
D. 扩展ACL可以根据不同的上层协议信息进行过滤
7. [单选题]After working on a router, some problems arise and you wish to view the commands that you recently entered. Which IOS command opens the history buffer and displays the most recently entered commands?
A. Show history
B. Show buffers
C. Show typed commands
D. Show terminal buffer
E. Show command
F. F. None of the above
8. [单选题]在启用IGRP协议时，所需要的参数是：()
A. 网络掩码
B. 子网号
C. 自治系统号
D. 跳数
9. [单选题]如果网络中的路由器都是cisco路由器，则优先选择哪一个路由协议（）
A. RIP
B. EIGRP
C. IGRP
D. OSPF
10. [单选题]备份路由器IOS的命令是：()
A. copy flash tftp
B. copy running-configt ftp
C. copy IOS tftp
D. copy startup-configt ftp
