【导读】
不凡考网发布计算机2020思科认证网络工程师易混易错每日一练(03月21日)相关信息，更多计算机2020思科认证网络工程师易混易错每日一练(03月21日)的相关资讯请访问不凡考网计算机类考试频道。
1. [单选题]You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which statement is true about full-duplex Ethernet when comparing to half-duplex Ethernet?
A. Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C. Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E. None of the above
2. [多选题]Regarding DHCP (dynamic host configuration protocol), which two of the following choices below are true? (Select two answer choices)
A. The DHCP Discover message uses FF-FF-FF-FF-FF as the Layer 2 destination address.
B. The DHCP Discover message uses UDP as the transport layer protocol.
C. The DHCP Discover message uses a special Layer 2 multicast address as the destination address.
D. The DHCP Discover message uses TCP as the transport layer protocol.
E. The DHCP Discover message does not use a Layer 2 destination address.
F. F. The DHCP Discover message does not require a transport layer protocol.
3. [单选题]The Ezonexam network administrator has issued the "VTP password ezonexam" command on a Cisco device. What is the purpose of this command?
A. It allows two VTP servers to exists in the same domain, each configured with different passwords
B. It is the password required when promoting a switch from VTP client mode to VTP server mode
C. It is used to access the VTP server to make changes to the VTP configuration
D. It is used to validate the sources of VTP advertisements sent between switches
E. None of the above
4. [单选题]帧中继环境中，在物理端口上，建立子接口的命令是（）
A. create
B. interface
C. encapsulation
D. ip address
5. [单选题]为了查看路由器的E0端口上，是否挂接了访问权限表，应该使用的命令是（）
A. show access-list
B. show interface e0
C. show ipinterface e0
D. show e0
