不凡考网

2021思科认证网络工程师加血提分每日一练(06月28日)

来源: 不凡考网    发布:2021-06-28     [手机版]    
  • 下载次数:
  • 支持语言:
  • 1961次
  • 中文简体
  • 文件类型:
  • 支持平台:
  • pdf文档
  • PC/手机

导读

不凡考网发布2021思科认证网络工程师加血提分每日一练(06月28日)相关信息,更多2021思科认证网络工程师加血提分每日一练(06月28日)的相关资讯请访问不凡考网计算机类考试频道。

1. [单选题]After working all night and successfully configuring a Cisco router for the Ezonexam network you save your changes on the startup config, reboot the router, and go out for a cigarette. When you return, none of your changes are active and the router boots to the initial configuration mode! Which of the choices below indicates the source of your problem?

A. Hardware failure in NVRAM prevents the router from loading the config
B. Startup-config in flash is corrupt and cannot be analyzed
C. Router configuration-register set to bypass startup configuration
D. Startup-config in NVRAM is corrupt and cannot be analyzed
E. None of the above


2. [多选题]Regarding DHCP (dynamic host configuration protocol), which two of the following choices below are true? (Select two answer choices)

A. The DHCP Discover message uses FF-FF-FF-FF-FF as the Layer 2 destination address.
B. The DHCP Discover message uses UDP as the transport layer protocol.
C. The DHCP Discover message uses a special Layer 2 multicast address as the destination address.
D. The DHCP Discover message uses TCP as the transport layer protocol.
E. The DHCP Discover message does not use a Layer 2 destination address.
F. F. The DHCP Discover message does not require a transport layer protocol.


3. [多选题]With regard to Ethernet media access methods, which of the following are true?(Choose all that apply.)

A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.


4. [单选题]路由器上,命令“show int s0”的显示结果为:Serial0 is up,line protocol is down出现该结果的可能原因是()

A. 端口处于关闭状态
B. 物理端口被烧毁
C. 两端设备协议不一致
D. 路由表中无路由


5. [单选题]关于PPP和HDLC的说法中,错误的是()

A. PPP是通用协议,HDLC是CISCO私有协议
B. PPP有验证功能,HDLC无验证功能
C. PPP效率低,HDLC效率高
D. 在配置ISDN时,广域网协议不能封装成PPP,但可以封装成HDLC


  • 查看答案&解析 点击获取本科目所有试题

  • 本文链接:https://www.zhukaozhuanjia.com/download/gzx6ln.html
    推荐阅读
    @2019-2026 不凡考网 www.zhukaozhuanjia.com 蜀ICP备20012290号-2