1. [单选题]You have just purchased a brand new router and wish to have the router prompt you through the initial configuration commands. Which router mode does this describe?
A. ROM Monitor mode
B. SETUP mode
C. Autoflash mode
D. RXBOOT mode
E. None of the above
2. [单选题]在OSPF的DR/BDR选举过程中，在路由器有相同的接口优先级情况下，什么用于确定DR或BDR（）
A. 最高的OSPF进程ID
B. 最低的接口IP地址
C. 最低的接口开销
D. 路由器ID
3. [单选题]把访问权限表应用到路由器端口的命令是：()
A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out
4. [单选题]帧中继(frame relay)环境中，在物理端口上，建立子接口的命令是（）
A. create
B. interface
C. encapsulation
D. ip address
5. [单选题]路由器“全局模式”的提示符为（）
A. >
C. (config)
D. (config-router)
6. [单选题]在OSI七层模型中，介质工作在哪一层()
A. 传输层
B. 会话层(session layer)
C. 物理层
D. 应用层
7. [单选题]路由器下“特权用户模式”的标识符(identifier)是：()
A. >
B. !
C.
D. (config-if)
8. [单选题]The network administrator has configured port security on a Ezonexam switch. Why would a network administrator configure port security on this Ezonexam device?
A. To prevent unauthorized hosts from getting access to the LAN
B. To limit the number of Layer 2 broadcasts on a particular switch port
C. To prevent unauthorized Telnet or SSH access to a switch port
D. To prevent the IP and MAC address of the switch and associated ports
E. None of the above
9. [多选题]Which of the following steps are necessary in order to add a new VLAN to the Ezonexam switched network? (Select all that apply)
A. Create the VLAN.
B. Name the VLAN.
C. Configure an IP address for the VLAN.
D. Add the desired ports to the new VLAN.
E. Add the VLAN to the VTP domain.
10. [多选题]下列哪一设备工作时，要用到OSI的七个层（一层到七层）（）
A. PC
B. 网管机
C. WEB服务器
D. 交换机
E. 路由器
