1. [单选题]OSPF骨干区的区域编号为（）
A. 0.0.0.1
B. 255
C. 0.0.0.0
D. 255.255.255.255
2. [单选题]路由器下“特权用户模式”的标识符(identifier)是：()
A. >
B. !
C.
D. (config-if)
3. [多选题]Which of the following steps are necessary in order to add a new VLAN to the Ezonexam switched network? (Select all that apply)
A. Create the VLAN.
B. Name the VLAN.
C. Configure an IP address for the VLAN.
D. Add the desired ports to the new VLAN.
E. Add the VLAN to the VTP domain.
4. [单选题]常见的LSA有几种类型()
A. 4
B. 5
C. 6
D. 7
5. [多选题]You need to configure a default route on a Ezonexam router. Which command will configure a default route on a router?
A. VE1(config) ip route 0.0.0.0 10.1.1.0 10.1.1.1
B. VE1(config) ip default-route 10.1.1.0
C. VE1(config) ip default-gateway 10.1.1.0
D. VE1(config) ip route 0.0.0.0 0.0.0.0 10.1.1.1
6. [单选题]如果把路由器的某个端口的IP配置为：192.168.10.64，掩码配置为：255.255.255.248，则该端口（）
A. 能和其他设备正常通信
B. 会变成“administratively down”状态
C. 端口被烧毁
D. 出现错误提示，配置命令执行失败
7. [单选题]OSI七层模型中，数据链路层的数据封装名称为（）
A. 比特
B. 帧
C. 包
D. 段
8. [多选题]You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)
A. Switch(vlan) mode trunk
B. Switch(config) switchport access mode trunk
C. Switch(config-if) switchport mode trunk
D. Switch(config-if) switchport trunk encapsulation dot1q
E. Switch(config) switchport access mode 1
F. F. Switch(vlan) trunk encapsulation dot1q
9. [单选题]The Ezonexam network administrator has issued the "VTP password ezonexam" command on a Cisco device. What is the purpose of this command?
A. It allows two VTP servers to exists in the same domain, each configured with different passwords
B. It is the password required when promoting a switch from VTP client mode to VTP server mode
C. It is used to access the VTP server to make changes to the VTP configuration
D. It is used to validate the sources of VTP advertisements sent between switches
E. None of the above
10. [单选题]在OSPF的完全存根区域中，使用以下哪种LSAType报文或其它方式与区域间通信：（）
A. LSAType1.2
B. LSAType3
C. LSAType4
D. 默认路由：0.0.0.0
