【名词&注释】
路由表(routing table)、路由器(router)、数据包(packet)、快捷键(shortcut key)
[单选题]A Ezonexam switch is configured with all ports assigned to VLAN 2. In addition, all ports are configured as full-duplex FastEthernet. What is the effect of adding switch ports to a new VLAN on this switch?
A. The additions will create more collisions domains.
B. IP address utilization will be more efficient.
C. More bandwidth will be required than was needed previously.
D. An additional broadcast domain will be created.
E. The possibility that switching loops will occur will increase dramatically.
查看答案&解析
点击获取本科目所有试题
举一反三：
[单选题]An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?
A. The cable is attached properly.
B. CDP has discovered the connected device.
C. Keepalives are being received on the interface.
D. A carrier detect signal has been received from the connected device.
E. IP is correctly configured on the interface.
[单选题]网关的功能（）
A. 过滤数据包
B. 不同网段通信
C. 校验数据帧
D. 把数据封装成“段”
[单选题]The Ezonexam corporate LAN consists of one large flat network. You decide to segment this LAN into two separate networks with a router. What will be the affect of this change?
A. The number of broadcast domains will be decreased.
B. It will make the broadcasting of traffic between domains more efficient between segments.
C. It will increase the number of collisions.
D. It will prevent segment 1's broadcasts from getting to segment 2.
E. It will connect segment 1's broadcasts to segment 2.
[多选题]You are bringing up a new Ezonexam switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?
A. Switch(config) switchport trunk encapsulation isl
B. Switch(config) switchport trunk encapsulation ietf
C. Switch(config-if) switchport trunk encapsulation isl
D. Switch(config-if) switchport trunk encapsulation ietf
E. Switch(config-if) switchport trunk encapsulation dot1q
[单选题]路由器上，清空路由表的命令是（）
A. clear ip
B. delete ip route
C. delete route
D. clearip route*
[单选题]路由器当前的模式为“端口模式”，要退回到“特权模式”，应该使用的快捷键(shortcut key)为（）
A. ctrl+b
B. ctrl+z
C. ctrl+c
D. ctrl+p
本文链接：https://www.zhukaozhuanjia.com/download/980jo4.html
