【导读】
不凡考网发布2022思科认证工程师每日一练在线模考(06月30日)相关信息，更多2022思科认证工程师每日一练在线模考(06月30日)的相关资讯请访问不凡考网计算机类考试频道。
1. [单选题]When is a switched network that is running the Spanning Tree Protocol considered to be fully converged?
A. when all switches have the same BID as the root switch
B. when all switches have received the MAC address of each neighboring switch
C. when every enabled switch port has been assigned a unique identifier
D. when every operating switch port is in either the blocking or forwarding state
E. when all switches are in either client, server, or transparent mode
2. [多选题]CDP is being used throughout the Ezonexam network. What are two reasons why the Ezonexam network administrator would use CDP? (Choose two)
A. To determine the status of network services on a remote device
B. To obtain the IP Address of a connected device in order to telnet to the device
C. To verify the type of cable interconnecting two devices
D. To verify Layer 2 connectivity between two devices when Layer 3 fails
E. To obtain VLAN information from directly connected swticehs
F. F. To determine the status of the routing protocols between directly connected routers
G. G. To support automatic network failover during outages
3. [多选题]You need to describe the various types of flow control to your co-workers. Which of the following are types of flow control that can be used in a network? (Choose three)
A. Congestion avoidance
B. Windowing
C. Cut-through
D. Buffering
E. Load Balacing
F. F. Fast Forward
4. [单选题]An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?
A. The cable is attached properly.
B. CDP has discovered the connected device.
C. Keepalives are being received on the interface.
D. A carrier detect signal has been received from the connected device.
E. IP is correctly configured on the interface.
5. [单选题]You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which statement is true about full-duplex Ethernet when comparing to half-duplex Ethernet?
A. Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C. Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E. None of the above
