【名词&注释】
正确答案:B。A.ROM Monitor mode B.SETUP mode C.Autoflash mode D.RXBOOT mode E.None of the above 更多思科认证的考试资料下载及答案解析请访问不凡考网计算机类考试考试频道。
[单选题]You have just purchased a brand new router and wish to have the router prompt you through the initial configuration commands. Which router mode does this describe?
A. ROM Monitor mode
B. SETUP mode
C. Autoflash mode
D. RXBOOT mode
E. None of the above
查看答案&解析
点击获取本科目所有试题
举一反三：
[单选题]The Ezonexam LAN is upgrading all devices to operate in full duplex. Which statement is true about full-duplex Ethernet in comparison to half-duplex Ethernet?
A. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
B. Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link
C. Full-duplex Ethernet can provide higher throughout than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex ethernet uses a jam signal
E. None of the above
[单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
[单选题]After connecting a PC to an available port on a switch, you find that the PC can not access any of the resources on the LAN. No other PC's connected to the switch appear to be having any issues. What is the most likely cause for this problem?
A. The router lacks a routing table entry for the new host
B. The host switch port is assigned to the incorrect VLAN
C. The host MAC address is incorrectly configured
D. A STP instance for the new host has not been initialized
E. The switch does not have the MAC address hard coded in the CAM table.
[单选题]What is the purpose of the spanning-tree algorithm in a switched LAN?
A. To provide a monitoring mechanism for networks in switched environments.
B. To manage VLANs across multiple switches.
C. To prevent switching loops in networks with redundant switched paths.
D. To segment a network into multiple collision domains.
E. To prevent routing loops in networks.
本文链接：https://www.zhukaozhuanjia.com/download/7r8gxj.html
