1. [单选题]An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?
A. The cable is attached properly.
B. CDP has discovered the connected device.
C. Keepalives are being received on the interface.
D. A carrier detect signal has been received from the connected device.
E. IP is correctly configured on the interface.
2. [单选题]The network administrator has configured port security on a Ezonexam switch. Why would a network administrator configure port security on this Ezonexam device?
A. To prevent unauthorized hosts from getting access to the LAN
B. To limit the number of Layer 2 broadcasts on a particular switch port
C. To prevent unauthorized Telnet or SSH access to a switch port
D. To prevent the IP and MAC address of the switch and associated ports
E. None of the above
3. [单选题]在OSPF的DR/BDR选举过程中，在路由器有相同的接口优先级情况下，什么用于确定DR或BDR（）
A. 最高的OSPF进程ID
B. 最低的接口IP地址
C. 最低的接口开销
D. 路由器ID
4. [单选题]Ezonexam has implemented the use of the Virtual Trunking Protocol (VTP). Which statement below accurately describes a benefit of doing this?
A. VTP will allow physically redundant links while preventing switching loops
B. VTP will allow switches to share VLAN configuration information
C. VTP will allow a single port to carry information to more than one VLAN
D. VTP will allow for routing between VLANs
E. None of the above
5. [多选题]You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)
A. Switch(vlan) mode trunk
B. Switch(config) switchport access mode trunk
C. Switch(config-if) switchport mode trunk
D. Switch(config-if) switchport trunk encapsulation dot1q
E. Switch(config) switchport access mode 1
F. F. Switch(vlan) trunk encapsulation dot1q
