1. [单选题]备份路由器IOS的命令是：()
A. copy flash tftp
B. copy running-configt ftp
C. copy IOS tftp
D. copy startup-configt ftp
2. [多选题]Ezonexam is migrating to a private IP addressing scheme. Which of the following describe the use of private IP addresses? (Choose two)
A. Addresses chosen by Ezonexam.com to communicate with the Internet.
B. Addresses that cannot be routed through the public Internet.
C. Addresses that can be routed through the public Internet.
D. A scheme to conserve public addresses.
E. Addresses licensed to enterprise or ISPs by an Internet registry organization.
3. [单选题]OSI七层模型中，“包”是哪一层数据封装的名称（）
A. 物理层
B. 数据链路层(data link layer)
C. 网络层
D. 传输层
4. [单选题]A Ezonexam switch is configured with all ports assigned to VLAN 2. In addition, all ports are configured as full-duplex FastEthernet. What is the effect of adding switch ports to a new VLAN on this switch?
A. The additions will create more collisions domains.
B. IP address utilization will be more efficient.
C. More bandwidth will be required than was needed previously.
D. An additional broadcast domain will be created.
E. The possibility that switching loops will occur will increase dramatically.
5. [多选题]In which Spanning-Tree states does a switch port learn MAC addresses? (Select two)
A. Blocking
B. Listening
C. Forwarding
D. Learning
E. Relaying
6. [单选题]路由器上的命令“show version”的功能是（）
A. 显示版本信息
B. 显示端口配置信息
C. 显示路由表
D. 显示路由协议信息
7. [单选题]默认情况下，RIP定期发送路由更新的时间是（）
A. 15S
B. 30S
C. 60S
D. 90S
8. [多选题]The LAN needs are expanding at the Ezonexam corporate office, which is quickly growing. You are instructed to enlarge the area covered by a single LAN segment on the Ezonexam network.Which of the following are layer 1 devices that you can use? (Choose all that apply.)
A. A switch
B. A router
C. A network adapter card
D. A hub
E. A repeater
9. [单选题]路由器上，命令“show int s0”的显示结果为：Serial0 is up,line protocol is down出现该结果的可能原因是（）
A. 端口处于关闭状态
B. 物理端口被烧毁
C. 两端设备协议不一致
D. 路由表中无路由
10. [多选题]The Ezonexam network administrator issues the ping 192.168.2.5 command and successfully tests connectivity to a host that has been newly connected to the network. Which protocols were used during the test? (Choose two)
A. ARP
B. CDP
C. DHCP
D. DNS
E. ICMP
