1. [单选题]路由器“全局模式”的提示符为（）
A. >
C. (config)
D. (config-router)
2. [单选题]You wish to segment your LAN into multiple broadcast domains. Which technology method should you implement in order to do this?
A. Transparent bridging
B. Cut-through switching
C. Fragment-free switches
D. Virtual LANs
E. Store-and-forward switching
F. F. None of the above
3. [单选题]在OSPF的DR/BDR选举过程中，在路由器有相同的接口优先级情况下，什么用于确定DR或BDR（）
A. 最高的OSPF进程ID
B. 最低的接口IP地址
C. 最低的接口开销
D. 路由器ID
4. [单选题]在OSPF的完全存根区域中，使用以下哪种LSAType报文或其它方式与区域间(inter-area)通信：（）
A. LSAType1.2
B. LSAType3
C. LSAType4
D. 默认路由：0.0.0.0
5. [单选题]对交换机的描述，正确的是（）
A. 单广播域，单冲突域的设备
B. 单广播域，多冲突域的设备
C. 多广播域，单冲突域的设备
D. 多广播域，多冲突域的设备
6. [多选题]There are 2 switches in the Ezonexam LAN, with no routers. Ports 1, 2 & 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 & 6 are assigned to VLAN 2 in both switches. These two switches are connected together via a trunked link. Which of the conditions below would verify trunk and VLAN operation? (Select all valid answers)
A. Host 1 on VLAN 1 can ping Host 2 on VLAN 1
B. Host 1 on VLAN 1 can ping Host 4 on VLAN 2
C. Host 1 on VLAN 1 can not ping Host 2 on VLAN 1
D. Host 4 on VLAN 2 can not ping Host 1 on VLAN 1
E. Host 4 on VLAN 2 can ping Host 2 on VLAN 2
7. [单选题]OSPF骨干区的区域编号为（）
A. 0.0.0.1
B. 255
C. 0.0.0.0
D. 255.255.255.255
8. [单选题]At which layer of the OSI model does the protocol that provides the information displayed by the "show cdp neighbors" command operate?
A. Transport
B. Physical
C. Application
D. Data link
E. Network
9. [单选题]介质工作在OSI的哪一层（）
A. 物理层(physical layer)
B. 数据链路层(data link layer)
C. 网络层
D. 传输层
10. [单选题]标准访问控制列表应被放置的最佳位置是在（）。
A. 越靠近数据包的源越好
B. 越靠近数据包的目的地越好
C. 无论放在什么位置都行
D. 入接口方向的任何位置
