1. [单选题]RIP路由协议认为“网络不可到达”的跳数是：()
A. 8
B. 16
C. 24
D. 100
2. [多选题]Which three statements are true about the operation of a full-duplex Ethernet network, which is being used in the Ezonexam LAN? (Choose three)
A. Ethernet hub ports are preconfigured for full-duplex mode.
B. The host network card and the switch port must be capable of operating in full-duplex mode.
C. There are no collisions in full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
E. A dedicated switch port is required for each full-duplex node.
3. [单选题]基本IP访问权限表的表号范围是：()
A. 1—100
B. 1-99
C. 100-199
D. 800-899
4. [单选题]路由器上，命令“show int s0”的显示结果为：Serial0 is up,line protocol is down出现该结果的可能原因是（）
A. 端口处于关闭状态
B. 物理端口被烧毁
C. 两端设备协议不一致
D. 路由表中无路由
5. [单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
6. [多选题]As a Ezonexam trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?
A. TestKSwitch(config) ip route-default 192.168.1.115
B. TestKSwitch(config) ip default-gateway 192.168.1.115
C. TestKSwitch(config) ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config) ip default-network 192.168.1.115
E. None of the above
7. [单选题]默认情况下，RIP定期发送路由更新的时间是（）
A. 15S
B. 30S
C. 60S
D. 90S
8. [单选题]RIP协议负载均衡的路径数量为（）
A. 无限制
B. 最多4条
C. 最多5条
D. 最多6条
9. [单选题]TELNET工作在OSI哪一层（）
A. 会话层(session layer)
B. 表示层
C. 传输层
D. 应用层
10. [单选题]100baseT的速率是()Mbit/s
A. 1
B. 10
C. 100
D. 1000
