1. [多选题]Two stations on the Ezonexam LAN transmit at the same time, resulting in a collision. What happens when a collision occurs on the network? (Choose all that apply)
A. Each device on the Ethernet segment stops transmitting for a short time.
B. A jam signal informs all devices that a collision occurred.
C. When data transmission resumes, the devices that were involved in the collision have priority to transmit.
D. The devices that are involved in the collision stops transmitting for a short time.
E. The collision invokes a random back-off algorithm.
2. [单选题]混合型协议既具有“距离矢量路由协议”的特性，又具有“链路状态路由协议”的特性，下列协议中属于混合型协议的是：()
A. RIP
B. OSPF
C. EIGRP
D. IGRP
3. [单选题]当配置一个CISCO的路由器时，缺省的DR和BDR优先级(priority)是（）。
B. 1
C. 16
D. 255
4. [单选题]查看E0端口配置信息的命令是：()
A. show access-list
B. show ip route
C. show version
D. show interfacee0
5. [多选题]The Ezonexam network administrator needs to determine what LAN devices to install on the Ezonexam network. What are two advantages of using Layer 2 Ethernet switches over hubs? (Choose two)
A. Allowing simultaneous frame. transmissions
B. Increasing the size of broadcast domains
C. Increasing the maximum length of UTP cabling between devices
D. Filtering frames based on MAC addresses
E. Decreasing the number of collision domains
6. [多选题]When you compare the differences between half-duplex and full-duplex Ethernet, which of the following characteristics are exclusive to half-duplex? (Select two answer choices)
A. Half-duplex Ethernet operates in a shared collision domain.
B. Half-duplex Ethernet operates in an exclusive broadcast domain.
C. Half-duplex Ethernet has efficient throughput.
D. Half-duplex Ethernet has lower effective throughput.
E. Half-duplex Ethernet operates in an exclusive collision domain.
7. [单选题]为了使配置私有IP的设备能够访问互联网，应采用的技术是()
A. NAT
B. VLAN
C. ACCESS-LIST
D. DDR
8. [单选题]路由器上激活端口的命令是（）
A. shutdown
B. no shutdown
C. up
D. noup
9. [多选题]Which of the following steps are necessary in order to add a new VLAN to the Ezonexam switched network? (Select all that apply)
A. Create the VLAN.
B. Name the VLAN.
C. Configure an IP address for the VLAN.
D. Add the desired ports to the new VLAN.
E. Add the VLAN to the VTP domain.
10. [单选题]路由器上，设置端口速率的命令是（）
A. clock rate
B. bandwidth
C. set
D. encap
