【名词&注释】
路由器(router)、服务器(server)、端口号(port number)
[多选题]Which of the following steps are necessary in order to add a new VLAN to the Ezonexam switched network? (Select all that apply)
A. Create the VLAN.
B. Name the VLAN.
C. Configure an IP address for the VLAN.
D. Add the desired ports to the new VLAN.
E. Add the VLAN to the VTP domain.
查看答案&解析
点击获取本科目所有试题
举一反三：
[单选题]After working on a router, some problems arise and you wish to view the commands that you recently entered. Which IOS command opens the history buffer and displays the most recently entered commands?
A. Show history
B. Show buffers
C. Show typed commands
D. Show terminal buffer
E. Show command
F. F. None of the above
[单选题]为了查看路由器的E0端口上，是否挂接了访问权限表，应该使用的命令是（）
A. show access-list
B. show interface e0
C. show ipinterface e0
D. show e0
[单选题]哪个ACL可允许主机10.220.158.10访问web服务器192.168.3.244()
A. access-list 101 permit tcp host 10.220.158.10 eq 80 host 192.168.3.224
B. access-list 101 permit tcp 10.220.158.10 0.0.0.0 host 192.168.3.224 0.0.0.0 eq 80
C. access-list 101 permit host 10.220.158.10 0.0.0.0 host 192.168.3.224 0.0.0.0 eq 80
D. access-list 101 permit tcp 10.220.158.10 0.0.0.0 host 192.168.3.224 eq 80
[单选题]An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?
A. The cable is attached properly.
B. CDP has discovered the connected device.
C. Keepalives are being received on the interface.
D. A carrier detect signal has been received from the connected device.
E. IP is correctly configured on the interface.
[单选题]100baseT的速率是()Mbit/s
A. 1
B. 10
C. 100
D. 1000
[单选题]You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which statement is true about full-duplex Ethernet when comparing to half-duplex Ethernet?
A. Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C. Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E. None of the above
[多选题]You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)
A. Switch(vlan) mode trunk
B. Switch(config) switchport access mode trunk
C. Switch(config-if) switchport mode trunk
D. Switch(config-if) switchport trunk encapsulation dot1q
E. Switch(config) switchport access mode 1
F. F. Switch(vlan) trunk encapsulation dot1q
[单选题]TCP23是（）协议端口号；UDP69是（）端口号；TCP80是（）端口号。
A. TELNET FTP HTTP
B. FTPT FTP HTTP
C. TELNET TFTP HTTP
D. TELNET DNS HTTP
本文链接：https://www.zhukaozhuanjia.com/download/38jgpn.html
