1. [单选题]对于使用链路状态路由协议的路由器如何选择最佳路线到达子网，下列哪项是正确的（）
A. 路由器会发现链路状态数据库中的最佳路由
B. 通过针对链路状态数据库中的信息运行SPF算法，路由器会计算出最佳路由
C. 路由器将比较每个邻居接收到的更新中为子网列出的标准，并挑选最佳标准路由
D. 路由器会使用具有最低条数的路径
2. [单选题]帧中继环境中，CIR的含义是（）
A. 提高线路速率
B. 保证线路速率
C. 降低线路速率
D. 配置线路速率
3. [单选题]An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?
A. The cable is attached properly.
B. CDP has discovered the connected device.
C. Keepalives are being received on the interface.
D. A carrier detect signal has been received from the connected device.
E. IP is correctly configured on the interface.
4. [单选题]IP地址为：192.168.50.70，掩码为：255.255.255.248，则该IP地址所在子网的广播地址为（）
A. 192.168.50.32
B. 192.168.80.64
C. 192.168.50.96
D. 192.168.50.71
5. [单选题]为了使配置私有IP的设备能够访问互联网，应采用的技术是()
A. NAT
B. VLAN
C. ACCESS-LIST
D. DDR
6. [单选题]配置路由器特权用户“加密密码”的命令是：()
A. password
B. enable password
C. enable secret
D. passwd
7. [单选题]Assuming you build networks to exact specifications, what is the recommended maximum length a 10BaseT cable can be before it has to be segmented or repeated?
A. 100 meters
B. 100 feet
C. 100 yards
D. 200 meters
E. None of the above
8. [单选题]A Ezonexam technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command.In which OSI layer is the problem most likely occurring?
A. Physical
B. Data link
C. Network layer
D. Transport layer
E. Application layer
9. [单选题]A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?
A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.
E. None of the above
10. [单选题]You have just purchased a brand new router and wish to have the router prompt you through the initial configuration commands. Which router mode does this describe?
A. ROM Monitor mode
B. SETUP mode
C. Autoflash mode
D. RXBOOT mode
E. None of the above
